Sigma CP supplied by Kentec Electronics
The Sigma CP range of conventional fire control panels are designed for the most demanding of conventional fire detection and alarm system applications.
Easy to install, the Sigma CP is available with two, four or eight detection zones in standard or installation saving, ‘two-wire’ versions.
The extensive range of configuration features available ensure suitability for new installations or panel replacements on older systems.
Configuration options are stored in non-volatile memory and are easily accessed via an intuitive user interface, which enables the configuration data to be viewed and changed efficiently.
Sigma CP control panels are compatible with most standard, conventional detectors, call points and sounders and are also compatible with ‘two wire’ detector bases from Apollo and Hochiki.
Main features
- Two-wire and standard versions in two, four or eight zones
- Compatible for use on BS5839: Part 1: 2017 installations
- Two-wire repeaters and ancillary boards
- Simple, single board construction
- Installer friendly
- Compatible with wide range of detection devices
- Two monitored sounder outputs
- Three Amp power supply
- Auxiliary power output
- Fully certified to BS EN54-2 and BS EN54-4
Fully programmable using simple menu options
- Adjustable sounder delay time
- Sounder configuration options
- Zonal sounder delay detectors only
- Zonal sounder delay call points only
- Coincidence input selection
- I.S. Barrier selection by zone
- Short circuit fire by zone
- Non latching zones
- Silent zones
- Zone input delay
- General panel configuration
Powerful Features
The simple and intuitive programming interface on Sigma CP panels allows simple configuration of many parameters by entering simple codes which are listed on the inner door look up table and in the operation and maintenance manual.
Connectivity
Sigma CP control panels have a dedicated ‘two-wire’ serial bus for connection of repeater panels, ancillary relay boards or zonal sounder extension boards. Up to seven units may be connected to the serial bus which can be up to 1200 metres in length.
Ease of Installation
The elegant and simple construction of the panel enables the chassis to be completely dismantled by removing just two screws.
Sigma CP supplied by Kentec Electronics
Telephone: +44 (0)1322 222121 Email: Click to email Website: Click to visit website
To contact this supplier or receive more details please complete the request form below.
Other products by Kentec Electronics
